JINDAL PE-X TUBES PVT. LTD.

Jointing Procedure for Screw Fittings 1a. Cut off Jindal MLC Pipe vertically with the Pipe Cutter. 2a. Round and bevel the end holes and make inclines of atleast 2 mm. 3a. Choose the right size of fitting; put the nut over the pipe and slide the compression ring over the pipe. Make sure that the mouth of the mut and the pipe faces the same direction. 4a. Push the inserts into the pipe up to the shoulder. Take care not to damage the O-ring. 5a. Use a spanner to tighten it up completely.
The pipe is bended using internal bending spring. The Aluminum makes the pipe form-stable (i.e. non spring-back after bending) & impermeable to oxygen diffusion. Once bent, the pipe maintains its shape.
Jointing Procedure for Press Fittings 1b. Cut off Jindal MLC Pipe vertically with the Pipe Cutter. 2a. Round and bevel the end holes and make a pouring angle. 2b. Insert the Fitting into the pipe till the pipe end tightly reaches the shoulder of the fitting. 3b. Install the fitting pressing clamp according to the instruction manual. Put the sleeved fitting into the clamp jaw and press the clamp until the jaws are completely closed. Now the pressing is finished. For manual pressing clamp, close the jaw manually until the automatic ratchet releases.

2010, JINDAL PE-X TUBES PVT. LTD.